TM-9-2350-247-20-2 Unit Maintenance Manual Volume 2 M548A1 M548A3 Tracked Cargo Carrier Download
Page 278 of 1072
TM 9-2350-247-20-2 REPLACE ENGINE EXHAUST PIPE GUARD (M548A1) — Continued 0208 00 INSTALLATION 1. Mark exhaust pipe (1) 7 3/4 and 17 inches (19.68 and 43.18 cm) from the bottom. 2. Install two bottom bracket clamps (2) just above the 7 3/4 inch (19.68 cm) mark. 3. Install two top bracket clamps (2) just above the 17 inch (43.18 cm) mark. NOTE Be sure to install bracket clamps so that guard brackets are attached above top clamp and below bottom clamp. 4. Secure four bracket clamps (2) on exhaust pipe (1) with four screws (3), new lock nuts (4), and eight washers (5). 5. Attach four guard brackets (6) to bracket clamps (2) with eight screws (7) and washers (8). Do not tighten screws. 6. Slide guard (9) over exhaust pipe (1). Secure guard to guard brackets (6) with 8 screws (10), new lock nuts (11), and 16 washers (12). 7. Tighten eight screws (7). END OF TASK 0208 00-2