TM-9-2350-247-20-2 Unit Maintenance Manual Volume 2 M548A1 M548A3 Tracked Cargo Carrier Download
Page 242 of 1072
TM 9-2350-247-20-2 ADJUST ACCELERATOR LINKAGE (M548A3) — Continued 0200 00 ADJUSTMENT FOR FULL THROTTLE 1. Loosen pedal toe stop screw (1) and jam nut (2). 2. (H) Press accelerator pedal (3) until edge of connector pin (4) is 1/32 to 1/16 inch (1 to 1.5 mm) away from washer (5). Adjust pedal toe stop screw (1) and tighten jam nut (2). FOLLOW-THROUGH STEPS 1. Start engine and check for proper idle and full power (see your -10). 2. Stop engine (see your -10). 3. Lower center seat (see your -10). 4. Install left center floor plate (WP 0395 00). 5. Install bottom access cover (see your -10). 6. Install power plant rear access panel (see your -10). END OF TASK 0200 00-4