TM-9-2350-247-20-2 Unit Maintenance Manual Volume 2 M548A1 M548A3 Tracked Cargo Carrier Download
Page 208 of 1072
TM 9-2350-247-20-2 ADJUST HAND THROTTLE CONTROL CABLE — Continued 0193 00 ADJUSTMENT NOTE Hand throttle control cable is adjusted the same way for M548A1 and M548A3. M548A1 control cable is shown. NOTE When accelerator pedal is against heel stop, accelerator is in idle position. 1. Adjust hand throttle control cable as follows: a. Loosen setscrew (1) in retainer collar (2). b. Push hand throttle control cable (3) flush against instrument panel. c. Place accelerator pedal in idle position. d. Place hand throttle control cable (3) through link pin (4) and into retainer collar (2). Tighten setscrew (1) in retainer collar to secure hand throttle control cable. e. Check accelerator pedal in full throttle position. Make sure hand throttle does not interfere. 2. Start engine (see your -10). Check hand throttle for proper operation. FOLLOW-THROUGH STEPS 1. Install/lower left center seat floor plate (WP 0394 00 or WP 0395 00). 2. Install throttle floor plate (WP 0394 00 or WP 0395 00). 3. Install left cab floor plate (WP 0394 00 or WP 0395 00). END OF TASK 0193 00-2