TM-9-2350-247-20-1 Unit Maintenance Manual Volume 1 M548A1 M548A3 Tracked Cargo Carrier Download
Page 801 of 870
TM 9-2350-247-20-1 REPLACE ENGINE OIL FILTER ASSEMBLY (M548A1) — Continued 0145 00 INSTALLATION 1. Clean external threads of elbow (1) and elbow (2) with cleaning compound. 2. Apply a thin even coat of sealing compound primer and sealing compound to cleaned external threads of elbow (1) and elbow (2) before installation. NOTE Washers (6) are used on the two top screws only. 3. Install oil filter assembly (3) on bracket (4) with four screws (5), two washers (6), and four nuts (7). 4. Install bushing (8) and sampling valve (9) on oil filter assembly (3). 5. Install elbow (1) and elbow (2) on oil filter assembly (3). 6. Install oil hose (10) and oil hose (11) on elbow (1) and elbow (2). 7. Install drain plug (12) in oil filter assembly (3) . 8. Add engine oil (WP 0128 00). FOLLOW-THROUGH STEPS 1. Connect battery negative lead (WP 0292 00). 2. Start engine (see your -10). 3. Check filter assembly for leaks. 4. Stop engine (see your -10). Wait about 20 minutes for engine oil to drain back to pan. Then check oil level. Add oil if needed (WP 0128 00). 5. Install top access cover and grilles (WP 0390 00). 6. Install power plant right rear access cover (see your -10). END OF TASK 0145 00-3/4 blank