TM-9-2350-247-20-1 Unit Maintenance Manual Volume 1 M548A1 M548A3 Tracked Cargo Carrier Download

Page 39 of 870

TM 9-2350-247-20-1 HOW TO USE THIS MANUAL (cont) If you are working with power unit items, use this point of reference. Think of the location as if you were standing at the transfer gearcase end of the power unit and facing the ﬂywheel. This rule applies whether the power unit is IN or OUT of the carrier. REFERENCES References within a procedure refer to a different manual or to another procedure in the same manual. They are found in the INITIAL SETUP and in the FOLLOW-THROUGH steps. For example. MASTER SWITCH OFF (see your -10) Battery ground lead disconnected (WP 0310 00, WP 0311 00, or WP 0312 00) For all procedures, the following comments apply: • Parts which are discarded when removed will be referred to as “new” in the procedure step when installed. Examples are: gaskets, lockwashers, some preformed packings, and some retaining rings. • These and other newparts are listed under MATERIALS/PARTS in the INITIAL SETUP. GENERAL MAINTENANCE Cleaning, inspecting, checking for leaks, and similar procedures which apply to most procedures are found in the GENERAL MAINTENANCE PROCEDURES section of the PMCS (WP 0128 00). Use these steps to clean and inspect any part being removed, repaired, or installed. Special cleaning will be covered in the procedure step. Below is a step that would require general cleaning. 5. Remove gasket (1) from upper tube ﬂange (2). Discard gasket. xxi