TM-9-1240-216-34 Maintenance Manual M19 and M24 Persicope Download
Page 78 of 176
TM 9-1240-216-34 FRAME 6 Step 1. 2. 3. 4. 5. 3-2. BODY ASSEMBLY INSPECTION UPON RECEIPT (CONT) Procedure Check short stud (1) on plate assembly (2) for one washer (3) between segment (4) and lock nut (5). Using open-end wrench, check that lock nut (6) is tight. Move segment (4) through its full travel and check for binding. Maintenance Action Replace if damaged or missing. Tighten. Replace if missing or damaged. Clean and lubricate. Repair or replace if it binds. NOTE Do steps 4 and 5 for M24 configurations only. Line up notch in segment (4) with screw (7) holding plate assembly (2) to support (8) on body assembly (9), Tighten locking lever (10). Using 3/16" screwdriver, check that screw (7) in plate assembly (2) under segment (4) is tight. GO TO FRAME 7 Tighten. Replace if missing. Reference Para 4-8 Para 4-8 Para 4-8 Para 4-8 Para 4-8 Para 3-2 Cont 3-8 Vol II