TM-9-1240-216-34 Maintenance Manual M19 and M24 Persicope Download
Page 114 of 176
TM 9-1240-216-34 4-18. BOARD ASSEMBLY AND GROUND WIRE ASSEMBLY INSTALLATION TOOLS: 3/16" flat tip screwdriver PERSONNEL: One EQUIPMENT CONDITION: Body assembly on work bench with head assembly removed; power supply disconnected NOTE Frame 1 is for M19 and M24 new configurations. Frame 2 is for M19 and M24 old configurations. NOTE This procedure is for either the left-hand or right-hand board assembly, but only the right-hand side has ground wire. FRAME 1 Step 1. 2. 3. 4. 5. 6. 7. 8. Procedure Using screwdriver, install wires (1) and (2), washer (3), and screw (4) on terminal board (5). Remove tags from wires. Using screwdriver, install ground wire (6), washer (7), and screw (8). Slide terminal board housing (9) over terminal board (5) until you feel the board (5) slip into a slot inside the housing (9). Place long screw (10) through lockwasher (11), ground wire (6), board assembly (5), spacer (12), and terminal housing (9). Place short screw (13) through lockwasher (14) and terminal housing (9). Place terminal housing (9) into body assembly (15). Using screwdriver, tighten short screw (13) and long screw (10) into body assembly (15). NOTE FOLLOW-ON MAINTENANCE Install cover (para 4-15). Do checkout procedure (Vol I, para 2-2). END OF TASK Para 4-18 4-30 Vol II