TB-9-2350-369-20-1 T130E1 to T150F Track Conversion M113 Family Download
Page 23 of 40
TB 9-2350-369-20-1 MODIFICATION PROCEDURES/SEQUENCING (continued) 0002 00 ASSEMBLY - Continued (12) Install inside end connector. Only a slight amount or no leverage is needed to install the second end connector if the outside end connector is already installed. (13) With the end connector installed half way on the inside of the track shoe, remove the track fixture and alignment track pin tool. Finish installing the end connector flush with the pin ends. WARNING Not getting the bolt tight enough may result in death to personnel and damage to equipment if the end connectors fall off during movement of the vehicle. Torque each end connector bolt to the proper torque of 400-430 lb- ft(543-583 Nm). NOTE Mark the location of the end connectors so they can be torqued properly. (14) TORQUE END CONNECTORS’ BOLTS TO 400-430 lb-ft (543-583 NӦ m). Make sure to check every end connector bolt on the complete track assembly, even if it came in as a complete assembly. (15) Repeat installation procedures to the opposite side of the vehicle. (16) Adjust track tension (see your -10). f. Install T150F Spare Track Shoes and Brackets on vehicle (Figure 9). Table 3. SPARE TRACK SHOE INSTALLATION COMPONENTS (OSV DOES NOT HAVE A STOWAGE LOCATION FOR THE SPARE TRACK SHOES) NSN NOMENCLATURE CAGEC PART NO. QUANITY 5340-01-496-5173 Bracket, Track, Stowage 19207 12474841 2 2530-01-496-4444 Track Shoe Assembly 19207 12474844 127or166 5310-01-497-2285 Washer, Flat, Square 19207 12474863 4 5305-00-071-2067 Screw, Cap, Hex 80204 B1821BH050C125N 4 5305-00-071-2069 Screw, Cap, Hex 80204 B1821BH050C150N 4 5310-00-809-5998 Washer, Flat 96906 MS27183-18 8 Not included in the kit (replaces B1821BH050C150N). For M981/M901A1 5305-00-071-2077 Screw, Cap, Hex 80204 B1821BH050C350N 4 0002 00-11