TB-9-2350-368-25 Powerplant Test Stand M113A2 M113A3 M548A1 M548A3 Download
Page 73 of 120
TB 9-2350-368-25 4-1 CHAPTER 4 OPERATION SECTION I. INTRODUCTION NOTE • OSV has A3 engine and TX200-4/4A transmission. • If testing OSV, refer to TM 9-2350-366 series. 4-1. GENERAL. This chapter tells you how to install the complete powerplant or the engine by itself on the powerplant test stand. Task will instruct you on how to connect the engine and how to start it. You should clean, inspect, check for leaks, and obey warnings from this TB and from the applicable Technical Manuals (TM 9-2350-277-20 Series for the M113A3 FOV, TM 9-2350-261-20 Series for the M113A2 FOV, TM 9-2350-247-20 Series for the M548A1 & M548A3, TM 9-2815-205-34 for all 6V53 engines, TM 9-2520- 254-34 for TX 100-1 transmissions, and TM 9-2520-272-34&P for X200-4 & 4A transmissions). Be sure to read all warnings, cautions, and notes in this TB. They help you avoid harm to yourself, other personnel, and equipment. They also tell you things you should know about the task. 4-2. DESCRIPTION/OPERATION. WARNING • Severe equipment damage will always result and personal injury can occur if the wrong voltage regulator is used. • Always disconnect the batteries’ ground cable(s) before removing or connecting cables to the regulator to avoid personal injury or equipment damage from the high amperage supplied by the batteries. CAUTION • The 100-amp voltage regulator, NSN: 2920-00-900-7993 is presently used in the M113A2 FOV. Late models M577A2s and M1068s have 200-amp voltage regulator, NSN: 2920-01-147-1574. Do not make connections to the 200-amp regulator if the engine is equipped with 100-amp generator. • The 200-amp voltage regulator, NSN: 2920-01-174-1574 is used in all M113A3/M548A3 FOVs. Do not make connections to the 100- amp regulator if the engine is equipped with a 200-amp generator. • Pin C of the regulator connector is the positive battery lead on the 200-amp regulator and pin C on the 100-amp regulator is the negative battery lead. Ensure that you have the right regulator for the application. If the regulator is not identified, do not use it. Using the wrong regulator will damage the alternator, engine wiring harness, the powerplant test stand's wiring harness, and powerplant test stand's regulator.