TB-9-2350-368-25 Powerplant Test Stand M113A2 M113A3 M548A1 M548A3 Download
Page 60 of 120
TB 9-2350-368-25 2-46 b. Brake Stall Test Tool Bill Of Materials Item Nomenclature Part Number NSN Qty 2” by 3” by 1/4” Steel Angle 1 10 inches (25.4 cm) 1 2 4 inches (10.2 cm) 1 1/4” Steel Plate 3 20 by 1 inch (50.8 by 2.5 cm) 1 4 1/4 by 3-1/4 inches (6.4 by 83 mm) 2 1/8” Steel Plate 5 6 by 1/8 inches (152 by 3.2 mm) 1 Rubber Hose 6 8 by 1 inch ID (20.3 by 2.5 cm) 1 7/16” ID Roll Steel 7 2 inches (5.1 cm) 1 Hardware/Components 8 Quick Release Pin MS17984 1 9 Chain 1 10 Washer MS27183-283 6 11 Nut MS51922-18 3 12 Clevis Rod End Connector MS35812-2 1 13 Screw B1821BH038C300N 3 14 Screw 24617-9425094 2 15 Washer 23018199 5310-01-216-1367 2 1. Measure 9 inches on one side of steel angle (1) and 10 inches on the other side. Scribe a line joining the marks. 2. Cut steel angle (1) at approximately 60° along scribed lines. 3. Measure 3 inches on one side of steel angle (2) and 4 inches on the other side. See Figure 2-28. Scribe a line joining the marks. 4. Cut steel angle (2) at approximately 60° along scribed lines. 5. Weld steel angles (1) and (2) along 60° angle. See Figure 2-28. 6. Scribe a line one inch from end of 1/4-inch steel plate (3) and four inches from the one inch scribe line. Scribe a line centered lengthwise (1/2 inch from edge). See Figure 2-28. 7. Drill two 3/8-inch diameter holes where scribe lines intersect. 8. Measure down the middle of 1/8-inch plate (4) and scribe a line. 9. Starting about 3/4-inch from end of 1/8-inch steel plate (4), scribe ten lines evenly spaced (approximately every 29/64). 10. Drill ten 1/4-inch holes where scribe lines intersect. See Figure 2-28. 11. Bend 1/4 inch on both ends of 1/8-inch steel plate (4) approximately 90°. 12. Using 1/8-inch plate (4) as template, drill ten 1/4-inch holes in 1/4-inch steel angle (1).