TB-9-2350-368-25 Powerplant Test Stand M113A2 M113A3 M548A1 M548A3 Download
Page 48 of 120
TB 9-2350-368-25 2-34 d. Regulator Cable (Three Leads) Bill Of Materials Item Nomenclature Part Number NSN Qty 1 Shell Assembly 8724262 5935-00-730-7325 1 2 Nut 7716634-1 5975-01-151-7033 1 3 Grommet 10874855 5935-00-784-1701 1 4 Nut 7723309 5310-01-248-3077 1 5 Electrical Wire M13486/1-5 6145-00-152-6499 or 6150-01-032-4556 A/R 6 Band Marker M43436/1-1 9905-00-752-4649 6 7 Terminal MS25036-153 5940-00-143-4774 2 8 Electrical Connector Shell 8338566 5935-00-572-9180 1 9 Slotted Washer 8338567 5310-00-833-8567 1 10 Electrical Contact MS27148-2 1 11 Electrical Insulation Tape 07099 - MS70T09-S 5970-00-955-9956 A/R Electrical Insulation Sleeving 78286-S6132- 61003-9 5970-00-004-4056 A/R NOTE See Figure 2-21 for regulator cable art. 1. Measure from the regulator to power buss bar and to accessory cable circuit lead 1B. 2. Connect three AWG 14 electrical leads (5), two or three inches longer than measurement in step 1, to receptacle (1-4). 3. Label leads (5), using band markers (7), from pin F, 1B; pin C, 2; and pin A, 2A. 4. Add connector (8), slotted washer (9), and electrical contact (10) to end of circuit lead 1B. 5. Add terminal (7) to ends of circuit leads 2 and 2A. 6. Install electrical insulation tape/sleeving (11) on all leads (5).