TB-9-2350-368-25 Powerplant Test Stand M113A2 M113A3 M548A1 M548A3 Download
Page 33 of 120
TB 9-2350-368-25 2-19 i. Instrument Panel Support Bill Of Materials Item Nomenclature Part Number NSN Qty 1” by 1” by 1/4” Steel Angle 1 15 inches (38.1 cm) 1 1” by 2” by 1/4” Steel Angle 2 1 inch (2.540 cm) 1 1/4” Steel Plate 3 1 by 3/4 inch (2.540 by 1.905 cm) 2 1/4” Rubber Bumper 4 3/4 by 3/4 inch (1.905 by 1.905 cm) 1 Hardware/Components 5 Washer MS27183-6 1 6 Quick Release Pin MS17984-C705 1 1/8” Aluminum Plate 7 11-7/8 by 14-7/8 inch (30.2 by 37.8 cm) 1 NOTE Dimension/measurements are not critical. The support is just a brace to support the instrument panel in the raised position. 1. Create hinge points and weld on left rear side 1/2” from rear, 1/2” from left side. Hinge is 2” wide and 2” high drilled with 3/8” hole centered 9/16” from top. 2. Fabricate 11-7/8” by 14-7/8” aluminum plate. Drill 3/4” hole 6-3/4” from top, 5” from right side. Mount rubber grommet in hole. 3. See Figure 2-13b for instructions on drilling holes so that wiring can be mounted in back. 4. Fabricate support rod to securely hold instrument panel upright. Exact fabrication can vary as long as the panel is secure.