TB-9-2350-277-40&P-1 M121 M1064A3 Crew Modification Kit Volume 1 Download
Page 46 of 100
TB 9-2350-277-40&P-1 INSTALLATION PROCEDURES – Continued 0005 00 0005 00-10 INSTALL GPS ANTENNA KIT 1. Position gasket (24) and GPS mount (51) over antenna opening. Point GPS arm toward the rear of carrier. 2. Route GPS cable (31) up and thru antenna opening, gasket (24), and groove (50) in GPS mount (51). Allow enough cable to connect to the GPS sensor. NOTE Remove and discard mounting plate from GPS sensor. 3. Connect the GPS cable (31) to the GPS sensor (49) and install GPS sensor on GPS mount (51) using two screws (53). 4. Adjust GPS cable (31) and secure to GPS mount (51) with three tie straps (52). WARNING Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you dizzy and irritate your eyes and throat. Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes. Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves. 5. Apply a generous amount of adhesive over GPS cable (31) and groove (50) of the GPS mount (51). Figure 8. GPS Mount Installation