TB-9-2350-277-40&P-1 M121 M1064A3 Crew Modification Kit Volume 1 Download
Page 42 of 100
TB 9-2350-277-40&P-1 INSTALLATION PROCEDURES – Continued 0005 00 0005 00-6 10. Arrange GPS cable (31), RCU cable (33), and power harness (32) along top of fuel tank and thru the indentation (23) in cable seal adapter (21). Ensure cables are not pinched. 11. Remove two screws (36), lockwashers (37), and washers (18) from angle bracket on top side of fuel tank. Discard screws, lockwashers, and washers. 12. Position guard (35) over cables and edge of cable seal adapter (21). Using holes in angle bracket, install cable guard (35) with two screws (36), lockwashers (37), and washers (18). 13. Remove two screws (22) previously installed in (Step 2, page 0005 00-4) that are temporarily securing cable seal adapter (21) to hull. WARNING Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you dizzy and irritate your eyes and throat. Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes. Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves. 14. Apply adhesive to area around cables and in indentation (23) of cable seal adapter (21). 15. Position a second gasket (24) and antenna base cover (34) on cable adapter seal (21) and secure with four screws (22).