LO-9-2350-266-12 Lubrication Order for M981 Armored Fire Support Download
Page 35 of 48
KEY EXPECTED TEMPERATURE LUBRICANTS/ CAPAC- Above +40°F 0°F to INTERVALS COMPONENTS ITIES +32°F -65°F (AP- (Above -10°F (-18°C PROX) 0°C) ( + 5°C -54°C) -23°C) GIA GREASE, As req S - Semi- MIL-G-23827) INSTRUMENT, annu- AIRCRAFT ALL ally or TEMPERATURES GAA Every GREASE, As req 1500 MIL-G-10924) AUTOMOTIVE AND Miles A - Annu- ARTILLERY ally OE/HDO Lubricat- es req MIL-L-2104D) ING OIL, OR INTERNAL OEA COMBUSTION MIL-L-46167) ENGINE # FOR ARCTIC OPERATION REFER TO FM 9-207 NOTES: 1. TACHOMETER AND SPEEDOMETER SHAFTS. Annually, disconnect shafts at both ends (TM 9-2350-261-20), remove slotted washers from drive ends of cores, and remove cores from instrument panel end of shafts. Clean and lubricate cores with GIA. Insert cores in shafts. Install slotted washers and connect both ends of shafts. If tachometer adapter has a grease fitting, lubricate sparingly with lubricant GIA. 2. OIL CAN POINTS. Every 1500 miles, semiannually, or as required, lubricate ramp hinges; ramp door hinges; power plant door hinges; trim vane hinges and latches; driver’s, commander’s and cargo hatch hinges; control linkage pins and shafts; and seat control. Lubricate air box heater air motor. Use OE/HDO or OEA, as appropriate. 3. LUBRICATE AT TIME OF ASSEMBLY. Coat ends of suspension torsion bar, idler wheel support arm spindle and bearings, steering control linkage bearing surfaces and pins, and towing pintle shaft with GAA or GIA as specified during assembly procedure. Pack new support arm and idler hub before assembling. Card 40 of 51/(52 blank)