LO-9-2350-266-12 Lubrication Order for M981 Armored Fire Support Download
Page 15 of 48
KEY LUBRICANTS/ COMPONENTS OE/HDO LUBRICAT- MIL-L-2104D) ING OIL, OR INTERNAL OEA COMBUSTION MIL-L-46167) ENGINE Transmission Final Drives # FOR ARCTIC OPERATION CAPAC- ITIES (AP- PROX) EXPECTED TEMPERATURE Above +32°F (Above 0°C) +40°F -10°F ( + 5°C -23°C) 0°F to -65°F -18°C -54°C) 16 qts 3-1/2 qts OE/ HDO- 15/40 OE/ HDO- 15/40 OEA PE- PE- 10-1 10-1 REFER TO FM 9-207 INTERVALS D – Daily S – Semi- annu- ally or Every 1500 Miles OC – On- Condi- tion NOTES: 1. When OE/HDO is used, this must not be mixed with single grade lubricants. 2. Complete oil change with filters is required when converting from OE/HDO to OEA (OEA to OE/HDO) in accordance with Key. CAUTION Transmission can be damaged when filled above FULL mark. Check transmission oil level before operation. Transmission oil level should be between ADD and FULL marks on gauge rod. NOTE Park carrier on level ground to check oil levels. Check/lubricate all oil and grease fitting point after washing or fording. 3. TRANSMISSION OIL LEVEL. Before operation, check transmission oil level. Remove driver’s access panel (TM 9-2350-266-10). Add oil (OE/HDO or OEA), as needed, to bring oil level between ADD and FULL marks on gauge rod. With engine disconnect engaged, start and run engine at 800 rpm for 3 to 5 minutes with range lever in 2-3 and brakes locked to allow ransmission oil to reach normal operating temperature. With engine idling, move range level through all ranges to assure complete oil circulation. Return range lever to N, and check transmission oil level with engine operating at 1500 rpm. Card 16 of 51/(52 blank)