LO-9-2350-247-12 Lubrication Order for M548A1 M548A3 M1015A1 Download
Page 4 of 43
KEY REFILL EXPECTED TEMPERATURES* LUBRICANTS/COMPONENTS CAPACITY INTERVALS (APPROX) +5°F to +120°F +40°F to -60°F OE/HDO (MIL-L-2104D) LUBRICATING OIL, 18 qt. OE/HDO-15/40 OEA AF - After OR OEA (MIL-L-46167) INTERNAL COMBUSTION ENGINE Engine (MIL-L-21260) PRESERVAllON OIL PE 30-1 OC - On Condition For Arctic Operation Refer to FM 9-207 NOTES 1. ENGINE OIL FILL. OE/HDO 15/40 MUST NOT be mixed with single grade lubricants. 2. A complete oil and filter change is required when converting to a different grade of oil in accordance with Temperature Key Chart. CAUTION Engine can be damaged if engine is filled above FULL mark. Do not fill engine above FULL mark. 3. ENGINE OIL LEVEL. After operation, check for oil level between F and L marks on gauge rod. Add oil as necessary. Oil level should not be above F (full) mark. 4. FREQUENCY OF AOAP SAMPLE. Every 30 days, obtain a sample of engine oil. Samples should be taken as near the prescribed interval as possible. If sampling at the prescribed interval is not possible, a 10 percent variance is permissible. 5. HARD TIME INTERVAL. If AOAP Laboratory sup- port is not available, then every 1,500 miles, or annu- ally, drain oil and change filter. Hard time interval may be shortened if you are operating the equipment under adverse conditions. 6. ENGINE OIL FILTER. See TM 9-2350-247-20 for engine oil filter removal/installation instructions. 7. ENGINE OIL DRAIN. See TM 9-2350-247-20 for instructions. NOTE Drain oil only when hot after engine operation. Allow oil to drain thoroughly. 8. PRESERVATION OIL. If engine has preservation engine oil Ieave this oil in engine until first scheduled oil change. Maintain operating oil level by adding required quantity of same grade oil. Card 4 of 40