LO-9-2350-247-12 Lubrication Order for M548A1 M548A3 M1015A1 Download

Page 11 of 43

LUBRICATION ORDER LO 9-2350-247-12 8 JULY 1994 (Supersedes LO 9-2350-247-12, March 1982) KEY EXPECTED REFILL TEMPERATURES* LUBRICANTS CAPAClTY +40°F 0°F INTERVALS (APPROX) Above to to 32°F -10°F -65°F OE/HDO (MIL-L-2104C) LUBRICATING OIL, AF - After OR OEA (MIL-L-46167) INTERNAL COMBUSTION S - 150 Hours, ENGINE 1,500 Miles Transmission 16 qt. OE/ OE/ OEA or Semi-annually HDO-10 HDO-10 OC - On Condition For Arctic Operation Refer to FM 9207 NOTES 1. TRANSMISSION (M548A1/M1015A1). After opera- marks on gauge rod (refill capacity 16 quarts). After filling tion, check transmission oil level for between ADD and transmission, check for oil leaks with engine running. FULL marks on gauge rod. With engine disconnect Recheck oil level. engaged, start and run engine at 800 rpm for 3 to 5 minutes with shift lever in 2-3 and brakes locked to allow WARNING transmission oil to reach all normal operating tempera- Dry cleaning solvent PD-880 is toxic and flam- ture. Move shift lever through all RANGES to assure mable. Death or injury may result. Always use in an complete oil circulation. Return shift lever to N and check open area with good air low, away from sparks, transmission oil level with engine operating at 1,500 rpm. heat, or flames. Wear protective goggles and gloves. Add oil (OE/HDO) as required. Every 25 hours of opera- Do not breathe vapors. Avoid contact with skin, tion or 30 days (whichever comes first), obtain a sample eyes, and clothes. If you get dizzy while using of oil and send this sample to the nearest AOAP Labora- solvent, breathe fresh air and get medical help. If tory. To obtain oil samples from AOAP valves: solvent gets on hands, wash them. If solvent gets in eyes, flush eyes with fresh water and get medical (1) Unlatch and raise grille behind cab on left side of help immediately. Keep fire extinguisher nearby. carrier. (2) Take oil sample of transmission oil, using proce- NOTE dures given in TB 43-0106. If transmission has been filled with (PE) oil (preserva- tive engine oil) by the manufacturer or at time of CAUTION overhaul, leave this oil in transmission until first Do not access AOAP valves from the power plant scheduled oil change. Maintain operating oil level by rear access panel opening as serious injury could adding ap Iicable grade of oil (OE/HDO). When first result from air brake compressor belts. schedule oil change is made, refill transmission with applicable grade oil (OE/HDO). OE/HDO is equiva- When AOAP Laboratory support is not available, drain lent to PE-10-1. transmission oil every 150 hours, 1,500 miles, or semi- annually. Drain only when hot after operation. To drain, When using On Condition for the transmission oil, remove hull bottom access cover (TM 9-2350-247-20) the transmission oil filter should be changed at hard and transmission drain plug. Catch oil in suitable con- time intervals tainer. Allow oil to drain thoroughly - 1 hour if time permits. Examine oil for evidence of overheating, foreign matter, and metallic particles. If metal chips or filings are found on plug or in oil, notify your supervisor. Clean and install drain plug, and INSTALL ACCESS COVER SE- CURELY. Service filter (see note 2). Add oil (OE/HDO) as required to bring oil level between FULL and ADD Card 11 of 40