LO-9-2350-247-12 Lubrication Order for M548A1 M548A3 M1015A1 Download
Page 40 of 43
KEY EXPECTED REFILL TEMPERATURES* FUEL CHART/COMPONENTS CAPACITY Above +40°F 0°F INTERVALS (APPROX) to 32°F to -10°F -65°F Diesel Fuel 2 qt. DF-2 DF-1 DF-A AF - After VV-F-800 AN - Every 1,500 Miles Fuel Filter or annually For Arctic Operation Refer to FM 9-207 NOTES 1. FUEL FILTERS. Daily, after operation, open drain cocks and drain water, debris, etc. from each filter until clear fuel is flowing into container. Dispose of waste through Unit SOP. 2. On M1015A1 carriers, Iift up and secure center seat support panel to access primary fuel filter drain cock. WARNING Dry cleaning solvent PD-680 is toxic and flam- mable. Death or injury may result. Always use in an open area with good airflow, away from sparks, heat, or flames. Wear protective goggles and gloves. Do not breathe vapors. Avoid contact with skin, eyes, and clothes. If you get dizzy while using solvent, breathe fresh air and get medical help. If solvent gets on hands, wash them. If solvent gets in eyes, flush eyes with fresh water and get medi- cal help immediately. Keep fire extinguisher nearby. 3. AIR BOX DRAIN/CRANCKCASE BREATHER COLLECTION CAN (M548A1/M1015A1). Weekly, re- move wing nuts. Lower can slowly to remove. Empty can, dispose of contents per Unit SOP, and reinstall (TM 9-2350-247-10). Every 25 hours, 250 miles, or monthly, empty can and remove element. Clean ele- ment and inside of can with dry cleaning solvent (PD- 680, type Ill) and reinstall. 4. OIL CAN POINTS. Every 1,500 miles, semi- annually, or as required, lubricate tailgate hinges, cargo door hinges, and driver’s throttle control linkage pins and shafts, and seat control. 5. LUBRICATED AT TIME OF ASSEMBLY. Coat ends of suspension torsion bar, idler wheel support arm spindle and bearings, steering control linkage bearing surfaces and pins, and towing pintle shaft with GAA or GIA as specified during assembly. Late model towing pintles do not have grease fittings and do not require lubrication. Pack new support arm and idler hub before assembly. A copy of this lubrication order will remain with the equipment at all times; instructions contained herein are mandatory. By Order of the Secretary of the Army: GORDON R. SULLIVAN General, United States Army Chief of Staff Official: MILTON H. HAMILTON Administrative Assistant to the Secretary of the Army 07303 DISTRIBUTION: To be distributed in accordance with DA Form 12-37-E, block 1403, requirements for LO 235<0-247-12. Card 40 of 40 U.S. GOVERNMENT PRINTING OFFICE: 1995 0- 398-894 (22013) PIN: 011897-000