LO-9-2350-247-12 Lubrication Order for M548A1 M548A3 M1015A1 Download

LUBRICATION ORDER LO 9-2350-247-12 8 JULY 1994 (Supersedes LO 9-2350-247-12, March 1982) KEY EXPECTED REFILL TEMPERATURES* LUBRICANTS CAPACITY +40°F 0°F INTERVALS (APPROX) Above to 32°F to -10°F -65°F OE/HDO (MIL-L-2104C) LUBRICATING OIL OE/ OE/ OEA S - 150 Hours, OR OEA (MIL-L-46167) lNTERNAL COMBUSTION 1/4 pt. HDO-10 HDO-10 1,500 Miles ENGINE Winch Transfer or Semi-annually Gearcase CW-11 (VV-L-751) LUBRICATING OIL C/MR - Upon CHAIN-WIRE ROPE, As Required CW-11B CW-11A GOS Contamination/ EXPOSED GEAR During Maintenance GO (MIL-L-2105) LUBRICATING OIL GEAR, MULTIPURPOSE Repair Winch End Frame 0.75 pt. GO- GO- GO-75 Winch Gear Box 2.75 pt. 80/90 80/90 GAA (MIL-G-10924) GREASE, AUTOMOTIVE AND ARTILLERY As Required All Temperatures Winch Drive Shaft For Arctic Operation Refer to FM 9-207 NOTES WARNING threads, and install plug. To fill, remove fill and level plugs Dry cleaning solvent PD-680 is toxic and flam- and add oil (OE/HDO) until oil level reaches bottom of mable. Death or injury may result. Always use in level plug hole (refill capacity 1/4 pint). Clean plugs, apply an open area with good air flow, away from sparks, a coat of sealing compound* to plug threads, and install heat, or flames. Wear protective goggles and plugs. During oil change, unscrew gearcase breather gloves. Do not breathe vapors. Avoid contact with and clean with dry cleaning solvent (PD-680, type Ill). Apply a light coat of sealing compound* to breather skin, eyes, and clothes. If you get dizzy while using threads and install breather. solvent, breathe fresh air and get medical help. If solvent gets on hands, wash them. If solvent gets 2. WINCH END FRAME (M548A1/M1015A1). Service in eyes, flush eyes with fresh water and get medi- cal help immediately. Keep fire extinguisher only when contaminated or during maintenance repair. Drain and refill winch end frame. To drain, remove plug in nearby. bottom of end frame. Inspect plug and oil for metallic 1. WINCH TRANSFER GEARCASE (M548A1/ particles. If found, notify your supervisor. Clean plug, M1015A1). Every 1,500 miles or semi-annually, drain apply a coat of sealing compound* to plug threads, and install plug. To fill, remove fill and level plugs, and add and refill winch transfer gearcase. To drain, remove drain gear lubricant (GO) until lubricant reaches bottom of level pIug in bottom of gearcase housing. Inspect plug and oil plug hole (refill capacity 3/4 pint). Clean plugs, apply a for metallic particles. If found, notify your supervisor. coat of sealing compound* to plug threads, and install Clean plug, apply a coat of sealing compound* to plug threads. Use sealing compound - 8030-00-543-4384 antiseize compound - 8030-00-286-5453, or Permatex - 5330-00-252-3391. Card 35 of 40