LO-9-2350-247-12 Lubrication Order for M548A1 M548A3 M1015A1 Download
Page 31 of 43
LUBRICATION ORDER LO 9-2350-247-12 8 JULY 1994 (Supersedes LO 9-2350-247-12, March 1982) KEY EXPECTED REFILL TEMPERATURES* LUBRICANTS CAPACITY Above +40°F 0°F INTERVALS (APPROX) to 32°F to -10°F -65°F OE/HDO (MIL-L-2104C) LUBRICATING OIL, As Required OE/ OE/ OEA S - Every 75 Hours OR OEA (MIL-L-46167) INTERNAL COMBUSTION HDO-10 HDO-10 on Engine Hour ENGINE Meter, semi- Shelter, Puller Wire, Rope annually CW-11 (VV-L-751) LUBRICATING OIL As Required C/MR - Upon CHAIN-WIRE ROPE, CW-11B CW-11A GOS Contamination/ EXPOSED GEAR During Shelter, Puller Wire, Rope Maintenance GAA (MIL-G-10924) GREASE, AUTOMOTIVE As Required Repair AND ARTILLERY All Temperatures Generator Drive For Arctic Operation Refer to FM 9-207 NOTES WARNING WARNING Disengage the engine disconnect (TM 9-2350-247- Use gloves when handling wire rope. Bare hands 10) before greasing generator drive universal joints. can be cut by broken strands. NOTE 1. GENERATOR DRIVE UNIVERSAL JOINT (2 If M1015A1 carrier has a shelter installed, it may be places). Every 75 hours on engine hour meter (on necessary (depending on the type of shelter) to carrier instrument panel tachometer) or semi-annu- slide shelter back on skid guides (see M1015A1 ally, remove drive shaft cover (TM 9-2350-247-20) and portion of TM 9-2350-247-10) for access to some lubricate. Each universal joint has two fittings, but only lubrication points. one requires lubrication. Reinstall drive shaft cover (TM 9-2350-247-20). 2. SHELTER PULLER WIRE ROPE. Service only when contaminated after use or during maintenance repair. Pay out wire rope from ratchet drum. Clean wire rope with oil (OE/HDO), wipe off excess oil, and coat with oil (CW-11). Ratchet in wire rope. Card 31 of 40