LO-9-2350-247-12 Lubrication Order for M548A1 M548A3 M1015A1 Download
Page 27 of 43
LUBRICATION ORDER LO 9-2350-247-12 8 JULY 1994 (Supersedes LO 9-2350-247-12, March 1982) KEY REFILL EXPECTED TEMPERATURES* LUBRICANTS/COMPONENTS CAPACITY INTERVALS (APPROX) +5°F to +120°F +40°F to -60°F OE/HDO (MIL-L-2104D) LUBRICATING OIL, 3.5 qt. or 7 pt. OE/HDO-15/40 OEA W - Weekly OR OEA (MIL-L-46167D) INTERNAL COMBUSTION ENGINE S - Semi-annually Final Drives or Every 1,500 Miles For Arctic Operation Refer to FM 9-207 NOTES 1. FINAL DRIVES. Weekly, check oil in both final c. Inspect drain plugs and oil for metallic drives for level between ADD and FULL marks on particles. If metal chips are found, notify direct gauge rod. Add applicable OE/HDO or OEA in accor- support maintenance. dance with Temperature Key Chart, as required. d. Clean and install drain plug. NOTE Drain only when hot after operation. e. Fill each final drive with OE/HDO or OEA, as applicable, adding the proper amount to bring Do not substitute hydraulic fluid for OE/HDO or level between the ADD and FULL marks on OEA. Red dye may have been added to some final gauge rod. drives to aid in detection of leaks. 2. FINAL DRIVE OIL DRAIN. Drain final drives every 1,500 miles, or semi-annually. a. Place a suitable container under final drive housing. b. Remove drain plug from final drive housing and drain oil into container. Card 27 of 40