LO-9-2320-260-12 Lubrication Order for M113A2 M577A2 M106A2 M125A2 M1059 M1064 M1068 Download
Page 35 of 42
NOTES 1. TACHOMETER AND SPEEDOMETER SHAFTS. Annually, disconnect shafts at both ends (TM 9-2350-261-20), remove slotted wash- ers from drive ends of cores, and remove cores from instrument panel end of shafts. Clean and lubricate cores with GIA. Insert cores in shafts. Install slotted washers, and connect both ends of shafts. If tachometer adapter has a grease fitting, lubricate spar- ingly with GIA. 2. OIL CAN POINTS. Every 1500 miles, semian- nually, or as required, Lubricate ramp hinges; ramp door hinges; power plant door hinges; trim vane hinges and latches; driver’s, commander’s and cargo hatch hinges; con- trol linkage pins and shafts, and seat control. Lubricate air box heater air motor. Use OE/HDO or OEA, as appropriate. 3. LUBRICATED AT TIME OF ASSEMBLY. Coat ends of suspension torsion bar; idler wheel support arm spindle and bearings; steering control linkage bearing surfaces and pins; and towing pintle shaft with GAA or GIA as specified during assembly. Late model tow- ing pintles do not have grease fittings and do not require lubrication. Pack new support arm and idler hub before assembly. CARD 28 of 32