TM-9-2815-202-34 Technical Manual for 8V71T Engines for M109 Howitzer Download
Page 516 of 670
TM9-2815-202-34 6-34. PISTON AND CONNECTING ROD MAINTENANCE (3) Connecting Rod (TRUNK TYPE) (Cont) (a) (b) Check connecting rod for visual damage. Scrap rod if bent, had previous bearing failure, was overheated (blued) at top or bottom end, or fretted at split line between rod and cap. Check for cracks by the magnetic particle method. NOTE Overheated bushings may become loose and creep together, thus blocking off supply of lubricating oil to piston pin and spray nozzle. (c) Check connecting rod bushings for indications of scoring, overheating, or other damage. Compressed air used for cleaning purposes will not exceed 30 PSI. Use only with effective chip guarding and personal protective equipment (goggles/shield, gloves, etc). (d) Check spray nozzle at upper end of connecting rod for plugged holes. Blow compressed air through drilled oil passage in rod to insure spray nozzle holes are open. (e) Inspect connecting rod bearing bores for burrs or foreign particles. Clean up minor burrs with crocus cloth using circular motion. 6-34