TM-9-2815-202-34 Technical Manual for 8V71T Engines for M109 Howitzer Download
Page 470 of 670
TM9-2815-202-34 5.1-11. AIR INLET HOUSING REPLACEMENT (Cont) (4) (5) (6) (7) (8) (9) (10) Screw threaded rod (10) into by-pass valve (11). Install spring (14) in valve, and place gasket (17) over valve bore on air inlet housing (5). Place hole in cover (9) over threaded rod , with words “OUT” facing outward. Install 5/1 6 inch flat washer (12) over rod. Using 5/1 6-18 hex nut (13) compress spring so cover is within 1/4 inch of air inlet housing. Aline gasket (17) and cover (9) with four holes in air inlet housing (5). Install four bolts (15) and four Iockwashers (16) and secure cover and gasket to housing. Torque bolts to 84-108 lb-in (9-12 N-m). Remove nut (13), flat washer (12) and threaded rod (10) from cover (9). Apply sealant to threads of elbow fitting (2) and install in by-pass valve cover (9) so end of fitting faces rear and downward at approximately 7:00 O’clock position for the right side cover. Repeat steps (1) thru (6) for opposite side. Apply sealant to threads of elbow fitting (2) and install in by-pass valve cover (9) so end of fitting faces rear and downward at approximately 4:00 O’clock position for the left side cover. Remove air inlet housing assembly (5) from soft-jawed vise. 5-90 Change 1