TM-9-2815-202-34 Technical Manual for 8V71T Engines for M109 Howitzer Download
Page 451 of 670
TM 9-2815-202-34 (16) (17) (18) (19) (20) (21) (22) (23) (24) (25) Insert control link operating Iever (72) and two washers (73) between two bosses inside governor housing (3). Install operating lever shaft (71) with grooved end up. Install locking clip (70) and screw and washer assembly (69) securing operating lever shaft in governor housing (3). Tighten screw (69) securely. Install buffer screw assembly (68) and locknut (67). Place governor housing (3) in soft- jawed vise. For models 7083-7391 and 7083-7396 only, assemble pin (66), governor link (64), and link (65) together. Install two retainer clips (63) and two springs (62). If removed, install pin (55) into differential lever (60). Install differential lever (60), washer (58), and spring clip (57) on operating lever (61 ) with slot facing rear of governor housing (3). Install operating lever connecting link (56) on differential lever (60) and secure with washer (54) and retaining clip (53) to pin (55). Using an arbor press and one-inch inside diameter sleeve, press weight shaft (51) into weight carrier (44) until shoulder of weight shaft is seated in carrier. NOiTE When installing weights, insure matchmarks made at disassembly are alined. (26) Lubricate outside diameter of needle bearing (50) with engine oil and inside diameter with grease. Using bearing installer (48), sleeve (49) and arbor press, install needle bearing (50) into high speed weight (42). Repeat procedure for other high speed weight (42). Change 1 5-71