TM-9-2815-202-34 Technical Manual for 8V71T Engines for M109 Howitzer Download
Page 396 of 670
TM 9-2815-202-34 5-14. ACCESSORY DRIVE REPLACEMENT (Cont) c. Cleanlng/inspection (1) Clean all parts with fuel bearing. WARNING Compressed air used oil except for cleaning purposes will not exceed 30 PSI. Use only with effective chip guarding and personal protective equipment (goggles/shield, gloves, etc.). (2) (3) (4) Dry all parts with compressed air. Inspect fiber coupling and shaft coupling half for cracks, wear, or damage. Inspect bearing and sleeve for scores, pitting, or wear. d. Assembly (1) (2) (3) (4) (5) (6) (7) 5-18 If removed, install cup plug (19) into shaft coupling half (16). Apply lubricant to each side of bearing (17) prior to installing on shaft coupling half (16). Apply sealant to inner diameter of bearing (17). Using arbor press, press bearing onto shaft coupling half (16). Apply sealant to inner diameter of sleeve (18). Using arbor press, press sleeve onto shaft coupling half (16). Sleeve must be flush with end of shaft. Apply sealant to outer diameter of bearing (17). Using arbor press, press shaft coupling half assembly (14) into accessory drive housing (13). If removed, install seal (15), part number out, into accessory drive housing (13). If removed, install six studs (12) into accessory drive housing (13). Torque studs to 12-17 Ib-ft (1 6-23 N-m).