TM-9-2815-202-34 Technical Manual for 8V71T Engines for M109 Howitzer Download
Page 361 of 670
(36) (37) (38) (39) TM 9-2815-202-34 Loosen locknut (74) and remove buffer screw assembly (75). Remove screw and washer assembly (76) and locking clip (77) securing operating lever shaft (78) to governor housing (3). Remove operating lever shaft (78), control link operating lever (79), and two washers (80). If bearings are damaged, support control link operating lever (79) on sleeve and rest sleeve on bed of arbor press. Place bearing remover (55) on top of bearing (81) and press two bearings (81 ) out of operating lever (79). (40) (41) (42) (43) (44) Remove expansion plug (82) from bottom of governor housing (3). Discard expansion plug. Remove operating shaft upper bearing retainer screw and washer assembly (83) and flat washer (84) securing bearing in governor housing (3). Place governor housing (3) in press, bottom side up. Press operating shaft (85) out of lower bearing (86) located in governor housing (3). Place a 9/16 inch open end wrench (87) under operating fork (88) and press fork off operating shaft (85). 4-253