TM-9-2520-234-35 Technical Manual for M109 Transmission XTG-411-2A Download
Page 9 of 323
Page 129 is changed as follows. Delete Paragraph 151 m . The shroud is no longer required. Page 134 is changed as follows. Paragraph 153at is changed to read: at. Remove left-brake apply cam stationary ring (fig. 190). Remove ring seal and expander from ring. Paragraph 153au is changed to read: au. Remove right-brake applv cam stationary ring (fig. 191). seal and expander from ring. Paragraph 156a is changed to a. Install any plugs in rear housing 25 that were Remove ring read: transmission removed for cleaning purposes. Torque 3/8-inch plug 22 (fig. 379, fold-out 8) to 12-16 pound- feet. Torque l-inch plug 27 to 70-90 pound-feet. Paragraph 156b is changed to read: b. Install new ring seal and expander onto right-brake apply cam stationary ring (fig. 191). Paragraph 156d is changed to read: d. Install new ring seal and expander onto left-brake apply cam stationary ring (fig. 190). Page 138 is changed as follows. Paragraph 156ag is changed to read: ag. Install the left-follower link shaft plug (fig. 198). Torque the 3/8-inch plug to 12-16 pound-feet. Paragraph 156aj is changed to read: aj. Install the right-follower link shaft plug (fig. 200). Torque the plug to 12-16 pound-feet. Page 139 is changed as follows. Paragraph 156ap is changed as follows: ap. Install the brake coolant pump idler gear shaft and secure with one 3/8-16 x 3-1/4 cap screw (fig. 176). Torque the cap screw to 26-32 pound-feet. Add the following Note immediately below Paragraph 158 heading: Note. The pinions in this planetary carrier are a matched set. There- fore, failure of one pinion requires replacement of the complete set. Page 141 is changed as follows. Change Note following Paragraph 161 heading to read: Note. Chill steer planetary car- rier spindles 11 (fig. 378, fold-out 7) in dry ice for approximately one hour prior to installation. Handle chilled parts with gloves. Add this N o t e following Paragraph 161k. — Note. Chilling of spindles results in "frost" initially which ultimate- ly is moisture. If a rebuilt carrier assembly is not being installed in a transmission in the near future, apply a coating of oil around spindle locations to avoid rust oxidation. Page 144 is changed as follows. The part number for the compressing tool in Figure 210 is 8355784. Delete both Notes from Page 144 follow- ing Steps k and 1. — — Page 145 is changed as follows. Delete Note following Paragraph 173a (l). Change 2 (5 of 13)