TM-9-2520-234-35 Technical Manual for M109 Transmission XTG-411-2A Download
Page 226 of 323
CHAP 5, SEC XXXIII ASSEMBLY PAR 229, STEPS 7-10 Figure 362 (Step 7) Install saddle and planetary assembly (A) onto output drive housing (B), alining index marks Install three 5/8-18 x 1-1/4 screws (C). Figure 363 (Step 8) Using lifting eye (A) and hoist to prevent out- put drive assembly (B) from turning, tighten 24 bolts (C). Using a 1-1/8-inch wrench, torque the bolts to 575-650 pound-feet. 194 Figure 364 (Step 9) Install input shaft (A), meshing it with the planetary pinions. Figure 365 (Step 10) Install alinement ring (A). Install saddle cap assembly (B). Install loosely six 3/8-24 x 1-1/4 bolts (C) with lock washers (D), since cap assembly is removed when unit is install- ed in vehicle. Note. Alinement ring (A) is used on only the right (shorter) assembly.