TM-9-2520-234-35 Technical Manual for M109 Transmission XTG-411-2A Download
Page 21 of 323
LIST OF WARNINGS ● White lead is toxic. To avoid injury, do not use white lead. ● Transmission and transmission components are heavy and can crush you. Have a ground guide check slings and lifting devices for cuts, breaks or wear before and during hoisting. Slings and lifting devices can break and cause injury or death. To avoid injury, do not stand under transmission or components when lifting them. ● Fumes from burning Teflon can cause serious injury or death. Because clutch piston seal rings and step-joint seal rings are made of Teflon, do not get rid of them by burning. ● Compressed shop air will not exceed 30 psi (pounds per square inch). Regulator assembly must be attached to compressor. To avoid injury, use only with effective chip-guarding and personal protective equipment (goggles/faceshield, gloves, etc.). ● Dry Cleaning Solvent P-D-680 is toxic and flammable. To avoid injury, wear protective goggles and gloves and use in a well-ventilated area. Avoid contact with skin, eyes, and clothes, and do not breathe vapors. Do not use near open fire or excessive heat. The flash point for Type I dry cleaning solvent is 100°F (38°C), and for Type II is 138°F (50°C). If you become dizzy while using dry cleaning solvent, get fresh air immediately and get medical aid. If contact with eyes is made, wash your eyes with water and get medical aid immedi- ately. Change 2 a.