TM-9-2520-234-35 Technical Manual for M109 Transmission XTG-411-2A Download
Page 199 of 323
PAR 227, STEPS 15-18 ASSEMBLY CHAP 5, SEC XXXIII Figure 254 (Step 15) Install the intermediate-range carrier and low-range ring gear assembly (A). This as- sembly will have to engage all high-range clutch plates and intermediate-range ring gear while being installed. Assembly is properly installed when external splines of the assembly touch, or nearly touch, the intermediate-range piston. Figure 255 (Step 16) Remove intermediate-range piston housing 3/8-16 x 1-3/4 bolt (A), lock washer (B) and flat washer (C). Install low-range clutch anchor (D). Using a pry bar (E), depress anchor (D) and install bolt (A), washer (B) and washer (C). Tighten the bolt (A) and then loosen slightly. Note. Place a piece of soft metal between the end of bar (E) and the con- tact surface of anchor (D). Figure 256 (Step 17) Install low-range clutch anchor bolt (A), wash- er (B) and 5/8-18 nut (C). Tighten nut only finger-tight at this time. Figure 257 (Step 18) Install four internal- (A) and four external- splined (J) low-range clutch plates alternately, beginning with an internal-splined plate (A). 167