TM-9-2520-234-35 Technical Manual for M109 Transmission XTG-411-2A Download
Page 194 of 323
CHAP 5, SEC XX XII LEFT, RIGHT OUTPUT SHAFT REBUILD PAR 222-2:!5 Section XXXII. LEFT- AND RIGHT-OUTPUT SHAFT ASSEMBLY -- REBUILD 222. DESCRIPTION Refer to pars. 26 and 27 for description of the left- and right-output shaft assemblies. 223. DISASSEMBLY a. Left - output Shaft Assembly — Ifig. 385, fold-out 14) (1) Using a 3/16-inch hexagon wrench, remove three pipe plugs from output shaft as- sembly (fig. 237). (2) Using a bearing remover, remove the output shaft bearing and related parts (fig. 238). Use the short-pin side of the special tool first, then the long-pin side, to complete the removal of the bearing. (3) Remove seal 46 (fig. 385, fold-out 14) and preformed packing 45 from spacer 44. Q. Right-output Shaft Assembly. The left - and r i g h t- output shaft assemblies are identical, therefore the disassembly proce- dure is the same as described in ~(l) through a(3), above. — 224. CLEANING Refer to par, 71 for cleaning recommen- dations. Figure 237. Removing pipe plugs from output shaft assembly 162 225. INSPECTION AND REPAIR Refer to par. 72 for general inspection and repair recoin mendat. ens. .Repair and re- build points of measuren]ents for fits, clear- ances and wear lilmits a::e indicated by small letters in figs. 385 and :~86, fold-outs 14 and 15. Refer to pars, 248 ar d 249 for wear limits information. II J Ill I l-- BEARING REMOVER (IMPROVISED TOOL) l-- WRING +-Figure .238. Remoz ing beari ag, retainer and seal from otiput shaft c ssembly *~iwre2.W. l~stalling seal onto output shaft spacer