TM-9-2520-234-35 Technical Manual for M109 Transmission XTG-411-2A Download
Page 191 of 323
PAR 206-211 TURBINE SHAFT REBUILD CHAP 5, SEC XXIX d. Install the output coupling with the bear~ng into the transmission housing. Install the retaining ring (fig. 232). – $c~ e. Po~i~ion the transmission housing on its b~ttom side. Install the accumulator bcdy and gasket. Secure the body with four 3/8- 16 x 1-l/2 and two 3/8-16x 2-1/2-inch cap screws with lock washers (fig. 233). +@ $ Install the oil filler tube assembly and gasket. Secure the assembly with four 3/8- 16 x 1 cap screws with lock washers. Install the gage rod cap. ~. Install the diaphragm assemb”ly in its housing bore (fig. 233). #C~h. Install the,iiaphragmclamp plate over the h=b of the diap:magm assembly (fig. 232). Aline the bolt holes in the plate with the dia- phragm :Lssembly. Install four 3/8-24x 2- l/2- inch self -locking d iaphra.gm bolts (fig. 233). i. 1 ns t a 11 two preformed packings on transmission housing (fig. 232 ). ~ Install two hook-type seal rings on hub of diaphragm assembly (fig. 232). Section XXIX. TURBINE SHAFT — REBUILIJ 207. DESCRIPTION The turbine shaft, of machined s t e e 1, serves as the torque converter output shaft. It is the input drive member to the transmis- .—. , sion range gearing, and is splined to the high- range clutch hub, intermediate-range and low- range sun gears. The shaft is splined to the turbine of the torque converter assembly. 208. DISASSEMBLY (fig. 375, fold-out 4) a. Remove four seal rings 1 and 3 from turb~e shaft 2. ~. Using a sleeve which will contact the inner race of thebearing, support the assem- bly in a press. Press the shaft out of the bearing (fig. 236). 209. CLEANING Refer to par. 71 for cleaning recommen- dations. 210. INSPECTION AND REPAIR -. Refer to par. 72 for general inspection and repair recommendations. Repair and re- build points of measurement for fits, clear- ances and wear limits are indicated by small, lower case letters in fig. 375, fold-out 4. Refer to par. 238 for wear limits information. 211. ASSEMBLY (fig. a. Install bearing :375, fold-out 4) 5 onto turbine shaft 2. Pres= the bearing im& race until it is firmly seated against it; shoulder on the shaft. - ~. Install three hook-type seal rings 3 and one seal ring 1 ontcl turbine shaft 2. ml ,! Figure 236. Removing bearing jrom turbine shu/t 159