TM-9-2520-234-35 Technical Manual for M109 Transmission XTG-411-2A Download
Page 188 of 323
*C2 *C2 *C2 CHAP 5, SEC XXVII HIGH CLUTCH REBUILD PAR 200-201 c. If the sleeve was removed from the clutch housing, install the sleeve 3/4-inch be- low the top edge of the housing (fig. 230). d. Install a hook-type seal ring on the hub of the high-range clutch housing (fig. 230). e. If seal ring and expander were re- moved from high-range clutch piston, install new replacements (fig. 230). f. Install the piston in the high-range clutch housing (fig. 230). g. Install 13 clutch piston return springs Figure 231. High-range clutch housing 66 (fig. 375, fold-out 4). 200. INSPECTION AND REPAIR h. Install the high-range clutch piston return spring retainer (fig. 229). Refer to par. 72 for general inspection and repair recommendations. Repair and re- i. Using a compressing tool (fig. 38), build points of measurement for fits, clear- compress piston return springs and install the antes and wear limits are indicated by small, lower case letters in fig. 375, fold-out 4. Re- fer to par. 238 for wear limits information. 201. ASSEMBLY (fig. 375, fold-out 4) a. If the bearing was removed from the high-range clutch housing, install a new re- placement. Press the bearing in until firmly seated in the housing. Install the retaining ring (fig. 231). b. If only bearing rollers were removed from the clutch housing for cleaning, grease the rollers lightly and install in the bearing race. Install the roller retaining ring (fig. 231). retaining ring that retains the retainer (fig. 229). j. Install the bearing on the hub of the high-range clutch housing (fig. 227). Press the bearing inner race until it is firmly seated on the hub. k. Install five internal- and four external- splined high-range clutch plates, beginning with an internal-splined plate (fig. 227). l. Install the high-range clutch reaction plate (fig. 227). m. Install the retaining ring that retains high-range clutch reaction plate (fig. 227). 156