TM-9-2520-234-35 Technical Manual for M109 Transmission XTG-411-2A Download
Page 184 of 323
*C2 *C2 *C2 CHAP 5, SEC XXVI INTERMEDIATE PLANETARY, LOW RING GEAR REBUILD PAR 191-195 the planetary carrier and position the spindle for installation. See fig. 222. Note. Be sure that the slot on the spindle is indexed properly with its lock pin bore in the carrier. i. With a press and spindle replacer 8351266, install planetary carrier spindle (fig. 222). The spindle replacer will bottom against the carrier when the spindle is properly posi- tioned in the carrier. j. Using a hammer and punch, install the planetary carrier spindle lock pin (fig. 219). Drive the pin in 0.030 to 0.060 below the surface of the carrier. Stake metal over the pin. Section XXVI. INTERMEDIATE-RANGE PLANETARY AND LOW-RANGE RING GEAR — REBUILD 192. DESCRIPTION Refer to pars. 12 and 13 for the descrip- tion of the intermediate-range planetary and low-range ring gear. 193. DISASSEMBLY (fig. 376, fold-out 5) Note. All related items not covered in a through d , below, were removed from the transmission as outlined in par. 75, steps 116, 123 and 124. No further disassembly of these parts is required. a. Remove retaining ring that retains the intermediate-range planetary carrier assem- bly in the low-range ring gear (fig. 223). Re- move the carrier assembly. b. Using a hammer and punch, remove four planetary carrier spindle lock pins (fig. 224). c. Using a press and a piece of 3/8-inch drill rod approximately 6 inches long, or other suitable press tool, remove four planetary spindles from the carrier (fig. 225). d. Remove planetary carrier pinions, spacers, thrust washers and bearing rollers from the carrier (fig. 225). 152 194. CLEANING Refer to par. 71 for cleaning recommen- dations. 195. INSPECTION AND REPAIR Refer to par. 72 for general inspection Figure 223. Removing (or installing) retaining ring that retains intermediate-range planetary carrier assembly