TM-9-2520-234-35 Technical Manual for M109 Transmission XTG-411-2A Download
Page 147 of 323
PAR 116 STEER VALVE BODY ASSEMBLY—REBUILD CHAP 5, SEC X Figure 152. Steer valve adjustment f. Install steer regulator valve 26 or 37 and steer valve stem 25 or 38 with seal 24 or 39 into the steer valve. g. Install nut 30 or 33 onto the valve stem. Adjust the nut to the dimension shown in fig. 152. h. Using a vise, squeeze the shoulder of the nut against the flat side of the stem. i. Install each steer valve assembly into the valve bore from which it was re- moved. j. Install the two steer valve cover plugs 31 and 32. Torque plugs 31 and 32 to 100-150 pound-feet. k. Using oil-soluble grease to retain it, install detent spring 42 into its bore (tube) in the bottom of the valve body. l. Install detent ball 43 into its recess on steer shaft assembly 45 and in- stall the shaft assembly into the bottom of the valve body. m. Install preformed packing 20 and steer indicator 21 onto the top of the steer shaft assembly. n. Secure the assembly with retain- ing rings 22 and 23. o. Install steer pressure regulator valve assembly 14 and two springs 12 and 13 into the valve body. p. Install steer valve cover 10 and gasket 11. Secure the cover with eight screws 8 and lock washers 9. Torque the bolts to 26-32 pound-feet. Change 2 115