TM-9-2350-311-34-1 Maintenance Manual for Volume 1 M109 Hull Download
Page 68 of 352
TM 9-2350-311-34-1 4-2 REMOVAL AND INSTALLATION OF ENGINE- AND TRANSMISSION-RELATED COMPONENTS — CONTINUED b. Installation — Continued 18 19 20 21 22 23 24 25 26 27 28 29 30 31 Install primary fuel filter (36), two nuts (35), two new Iockwashers (34), two flat washers (33), and two screws (32). Install primary fuel filter-to-engine-driven fuel pump tube (31 ). Install sleeve (30) and nut (29) and connect primary fuel filter-to-engine-driven fuel pump tube (31 ) to primary fuel filter (36). Remove screw (47) from transmission housing (14) and install tube clamp (48) and screw. Install three tube clamps (45 and 46), three nuts (43 and 44), three flat washers (41 and 42), and three screws (39 and 40). Connect elbow (37) to engine-driven fuel pump (38) and connect primary fuel filter-to-engine-driven fuel pump tube (31 ). Install all previously removed tubes between engine and transmission to prevent damage. Remove engine disconnect bracket (28). Temporarily remove two screws (26) and two Iockwashers (27) in transmission. Discard Iockwashers. Install bracket (28), two new Iockwashers (27), and two screws (26). Tighten screws. Connect four electrical connectors (22 thru 25). Install tachometer cable (20) and speedometer cable (21 ). Connect tachometer cable (20) to engine near generator. Remove nut (18), Iockwasher (17), flat washer (16), and screw (15) from mounting bracket (19). Discard Iockwashers. Secure speedometer cable (21 ) and tachometer cable (20) by installing screw (15), flat washers (16), new Iockwasher (17), and nut (18) to mounting bracket (19). 4-12