TM-9-2350-311-34-1 Maintenance Manual for Volume 1 M109 Hull Download
Page 148 of 352
Applicable Configurations Materials/Parts Equipment Conditions TM 9-2350-311-34-1 7-5 ENGINE DISCONNECT BRACKET-TO-BULKHEAD WIRING HARNESS (M109A2/M109A3) (ENGINE MODEL 7083-7391) This task covers: a. Removal b. Disassembly c. Assembly d. Installation INITIAL SETUP Lockwashers (2) (item 25, Appx F) M109A2/M109A3 Lockwashers (2) (item 42, Appx F) Tools References General mechanic’s tool kit (item 14, Appx C) TM 9-2350-311 -20-1 Electrical tape — black (item 25, Appx B) Batteries disconnected (TM 9-2350-311-20-1) Lockwasher (item 23, Appx F) Connector Wire No. Electrical Lead To: No. 1 2 3 4 5 6 7 8 9 10 11 Battery assembly to master relay Aeration detector-to-coolant indicator Aeration detector-to-coolant indicator Glow plug controller-to-glow plug lamp Engine oil pressure transmitter-to-engine oil pressure gage switch Engine coolant temperature transmitter- to-engine water temperature gage Transmission oil temperature transmitter-to- transmission oil temperature gage Transmission oil pressure transmitter-to- transmission oil pressure switch High/low temperature and pressure switches/transmitters-to-master warning light Not used Glow plug controller-to-glow plug switch 81 352B 352A 486A 36 33A 324 321 509 588 486 Connector Wire No. Electrical Lead To: No. 12 13 14 15 16 17 18 19 20 21 22 23 24 25 In-tank fuel pumps and generator system relay 76B Regulator cutoff relay coil energizer 27B Air cleaner blower motor circuit 415 Master switch voltage regulator lead 400-459B Engine starter circuit (starter relay bilge pump circuit breaker neutral safety switch) 14/14B Voltage regulator-to-master relay lead 2 Ground wire 3 Engine bracket disconnect connector Voltage regulator connector Starter relay connector Bilge pump circuit breaker lead Driver’s bulkhead connector Battery connectors Master relay connectors 7-12