TM-9-2350-311-34-1 Maintenance Manual for Volume 1 M109 Hull Download
Page 146 of 352
TM 9-2350-311-34-1 7-4 ENGINE DISCONNECT BRACKET-TO-BULKHEAD WIRING HARNESS (M109A2/M109A3) (ENGINE MODEL 7083-7396) – CONTINUED a. Removal 1 Remove two screws (26), two Iockwasher (27), two nuts (28), and two connectors (29) from batteries (30). Discard Iockwasher’s. 2 Remove nut (31), Iockwasher (32), and ground wire (33) from voltage regulator mount (34). Discard Iockwasher. 3 Remove nut (35), Iockwasher (36), and lead (37) from bilge pump circuit breaker (36). Discard Iockwasher. 4 Disconnect five connector (39 thru 43). 5 Remove engine-to-bulkhead wiring harness (44). b. Disassembly 1 Remove electrical tape only for sections being disassembled. 2 Separate/isolate wiring harness branches. 3 Disassemble wiring harness branches (TM 9-2350-311-20-1). c. Assambly 1 Assemble wiring harness branches (TM 9-2350-311-20-1). 2 Apply electrical tape only for sections being assembled. d. Installation 1 Install engine-to-bulkhead wiring harness (44). 2 Connect five connectors (39 thru 43). 3 Install lead (37), new Iockwasher (36), and nut (35) to bilge pump circuit breaker (38). 4 Install ground wire (33), new Iockwasher (32), and nut (31) to voltage regulator mount (34). 5 Install two connectors (29), two nuts (28), two new Iockwasher’s (27), and two screws (26) to batteries (30). 7-10