TM-9-2350-311-20-2 Maintenance Manual Volume 2 for M109 Cab Download
Page 419 of 828
TM 9–2350–311–20–2 Change 3 7–13 f. Adjustment 1 Check clearance between tray (24) and rammer mounting bracket (8). Clearance should be approximately 1/4 inch (6.4 mm). Refer to steps 2 through 6 to adjust. 2 Loosen two hex nuts (75). 3 Remove lockwire (6) from two cap screws (7). Discard lockwire. 4 Turn two cap nuts (7) to adjust rammer mounting bracket (8) to required clearance of 0.25 inch (6.4 mm). 5 Tighten two hex nuts (75). 6 Check clearance to make sure it has stayed at 1/4 inch (6.4 mm) during tightening. Repeat adjustment if necessary. 7 Install new lockwire (6) on two cap nuts (7). 8 75 7 1/4 ” (6.4 mm) 24 24 8 6 7 6 75