TM-9-2350-311-20-1 Maintenance Manual for Volume 1 M109 Hull Download
Page 877 of 1275
TM9-2350-311-20-1 9-9 SHlFT CONTROL LINKAGE AND NEUTRAL SAFETY SWITCH ADJUSTMENT This task covers: a. Removal b. Disassembly c. Assembly d. Installation e. Adjustment I INITIAL SETUP I TOOIS Cotter pins (6) (item 39, Appx G) General mechanic’s tool kit (item 64, Appx H) Lockwashers (15) (item 95, Appx G) Lockwashers (3) (item 96, Appx G) Materials/Parts Cotter pin (item 10, Appx G) Cotter pin (item 29, Appx G) Personnel Required Two a. Removal 1 Remove two cotter pins (1), two flat washers (2), two pins (3), and shift control inner rod (4). Discard cotter pins. 2 Remove three screws (5), three Iockwashers (6), and shift control (7). Discard Iockwashers. 3 Remove two cotter pins (8), flat washer (9), two pins (10), and shift control inner tube (11). Discard cotter pins. 4 Remove three screws (12), three Iockwashers (13), and support assembly (14). Discard Iockwashers. 5 Remove four screws (15), four Iockwashers (16), quick-release pin (17), and base assembly with shaft (18). (Quick-release pin is located in powerplant compartment at bulkhead.) Discard Iockwashers. 9-22