TM-9-2350-311-20-1 Maintenance Manual for Volume 1 M109 Hull Download
Page 867 of 1275
9-6 BREATHER, BREATHER TUBE, AND MOUNT — CONTINUED a. Removal—Continued Dry-cleaning solvent (P-D-680) is toxic and flammable. Wear protective goggles and gloves and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes, and don’t breathe vapors. Do not use near open flame or excessive heat. The flashpoint for type #1 is 100°F (38°C), and for type #2 is 138°F (59°C). If you become dizzy while using dry-cleaning solvent, get fresh air immediately and get medical aid. If contact with eyes is made, wash your eyes with water and get medical aid immediately. 4 Clean breather tube (8) using dry-cleaning solvent. 5 Remove breather elbow (3). 6 Remove two screws (4), two Iockwashers (5), two flat washers (6), and mount (7). Discard Iockwashers. Installation 1 Install mount (7), two flat washers (6), two new Iockwashers (5), and two screws (4); do not tighten screws. 2 Install breather elbow (3). 3 Install two sleeves (9) and breather tube (8). Tighten two tube nuts (2). 4 Tighten two screws (4), two Iockwashers (5), and two flat washers (6) on mount (7). 5 Install breather (1). 9-12 TM9-2350-311-20-1 WARNING