TM-9-2350-311-20-1 Maintenance Manual for Volume 1 M109 Hull Download
Page 85 of 1275
TM 9-2350-311-20-1 ITEM NO. 26 27 28 INTERVAL Annual Annual Annual ITEM TO BE INSPECTED Transmission Shifter Control Lever Neutral Safety Switch Starter Protection Relay PROCEDURE d. Push rod until knob contacts housing. Measure dimension between gaging balls. e. If dimension between balls is 0.436 in. (11 mm) or less, road wheel should be replaced. Move transmission shift control lever (40) to all positions. Shift control lever should not bind. If binding occurs, adjust as prescribed in paragraph 9-9. a. b. c. d. WARNING Clear personnel and equipment from near vehicle. Apply brakes. Place transmission gear lever in gear. Hold fuel shutoff control. Attempt to crank engine. If starter engages, stop immediately and follow system troubleshooting procedures in paragraph 3-3. Do starter protection relay procedures as follows: a. Pull fuel shutoff to prevent engine from starting during procedure (TM 9-2350-311-10). b. Engage starter (TM 9-2350-311-10). Note amount of time that starter cranks and when it stops. NOT FULLY MISSION CAPABLE IF: Dimension between gaging balls is less than 0.436 in. (11 mm) (TM 9- 2530-200-24). Transmission shifter control out of adjustment, excessive looseness, or binding. Starter engages in any gear but neutral. 2-37