TM-9-2350-311-20-1 Maintenance Manual for Volume 1 M109 Hull Download
Page 66 of 1275
TM 9-2350-311-20-1 2-13 WIRING HARNESS AND CABLE REPAIRS — CONTINUED 2-13.7 Typical Male-Type Plug with Ridged Locking Nut — Continued 2-13.7.2 Assembly a. Strip cable of insulation equal to depth of solder wells of pin contact. b. Slide nut over cable. c. Slide grommet over cable leads. d. Insert cable leads into solder wells of pin contacts and solder using resin core solder. e. Push insert into shell from rear until seated. Groove in insert must be alined with guide in shell to ensure proper fit. f. Push pin contacts into insert from rear until seated. g. Slide coupling nut onto shell assembly. h. Push grommet down cable leads and over solder wells of pin contacts. i. Screw nut onto shell assembly. 2-13.8 Cable Terminals and Connectors: Replacement Terminal-Type Cable Connector a. Strip cable insulation equal to depth of terminal well. b. Slide insulator over cable. c. Insert cable into terminal well and crimp. d. Slide insulator over crimped end of terminal. 2-18