TM-9-2350-311-20-1 Maintenance Manual for Volume 1 M109 Hull Download
Page 60 of 1275
TM 9-2350-311-20-1 2-13 WIRING HARNESS AND CABLE REPAIRS — CONTINUED 2-13.1 Cable Wires, Identifiers, Receptacles, and Plugs — Continued a. b. c. NOTE When removing more than one wire from a multiple wire receptacle, tag wires for later identification (ID). Cable identifiers (1) are aluminum tags attached to cables. These tags are embossed with the cable ID number. The ID number is the same number as shown on the system’s wiring diagram. Wire identifiers (2) are embossed with the individual wire number. The wire number is the same as shown on the systems wiring diagram. NOTE if cables or wires are replaced, remove tags from old wire and place them on new wires. All pins (male connectors) and sockets (female connectors) in receptacles and plugs are identified by alphabetic code. Coded ID starts at the connector key (3) or groove (4) and for: • Male connectors identifying letters run clockwise. • Female connectors identifying letters run counterclockwise. 2-12