TM-9-2350-311-20-1 Maintenance Manual for Volume 1 M109 Hull Download
Page 543 of 1275
TM 9-2350-311-20-1 5-11 SOLENOID VALVE AND BRACKET — CONTINUED Removal — Continued 5 Remove two screws (12), two Iockwashers (13), and two washers (14) and disconnect four wiring harness leads (15 and 16). Discard Iockwashers. 6 Remove two screws (17) and two Iockwashers (18). Discard Iockwashers. 7 Disconnect electrical lead (19). 8 Remove two screws (20), four flat washers (21), and bracket assembly (22) with solenoid valve (5) and electrical lead (23). 9 Remove two screws (24), two Iockwashers (25), and solenoid valve (5). Discard Iockwashers. 10 Remove four screws (26), four nuts (27), and electrical lead (23). b. Installation 1 2 3 4 5 6 7 8 9 10 11 12 5-22 Install electrical lead (23) with four nuts (27) and four screws (26). Secure wiring harness leads (15 and 16) to air inlet housing (28) with two washers (14), two new Iockwashers (13), and two screws (12). Torque screws to 16-20 Ib-ft (22-27 N•m). Install solenoid valve (5), two new Iockwashers (25), and two screws (24). Install hose (1) to connector (3) on solenoid valve (5). Position solenoid valve (5) with bracket assembly (22) on governor cover (8) inside bracket (29). Loosely secure solenoid valve and bracket assembly with four washers (21 ) and two screws (20). Do not tighten screws. Install two new Iockwashers(18) and two screws (17), securing solenoid valve (5) and bracket assembly (22) to support bracket (29). Torque screws to 30-35 Ib-ft (41-47 NŽm). Tighten two screws (20). Connect electrical lead (19). Install tee (11 ) into left cylinder head (1 O). Install connector (9) to tee(11 ). NOTE Engine model 7083-7396 does not use clamp (1) on hose (2). Install hose (2) into connector (9). Install clamp (1) on hose (2) and secure to governor cover (8) with screw (7).