TM-9-2350-311-10 M109 Operator's Manual for M109A2, M109A3, M109A4 and M109A5 Download
Page 388 of 775
TM 9-2350-311-10 2–20 OPERATION IN UNUSUAL ENVIRONMENT/WEATHER — CONTINUED 2-20.4 Operation in Extreme Cold — Continued e. Cold Weather Starting (Vehicles with LHR Engine Model 7083-7391) — Continued Do not engage starter for more than 2 minutes at a time (for M109A2 and M109A3 models this must be timed; it is an automatic function in M109A4 and M109A5 models). If engine speed does not reach 100 rpm after 15 seconds, release STARTER control switch and notify unit maintenance. NOTE M109A4 and M109A5 howitzers have a starter protection device in the engine compartment which will disengage starter automatically. The starter in all models must be disengaged after 60 seconds in temperatures between 0 and 50° F (–18 and 10° C) and after 120 seconds in temperatures below 0° F (–18° C). This will allow a 2 minute cooling off period between starting attempts. If engine (in M109A4 or M109A5 howitzers) does not start using STARTER control switch, proceed to step 8. 7 Set hand throttle control lever (17) to full throttle position. Turn on GLOW PLUGS switch (19) and release. The GLOW PLUGS indicator light (20) will turn on and stay lit. After 35 seconds the GLOW PLUGS indicator light will flash on and off. Hold STARTER control switch (14) on for 2 or 3 seconds but not more than 5 seconds. Engine should start and increase in speed. When engine speed reaches 1500-1800 rpm, reduce throttle speed to 1200-1500 rpm to warm up engine. NOTE • Attention should be focused upon the GLOW PLUGS indicator light during start-up. GLOW PLUGS are ON whether the GLOW PLUGS indicator light is lit continuously or flashing. • The GLOW PLUGS indicator light will not illuminate, or it will go out upon cranking the engine if voltage is insufficient. • When engine starter is engaged, GLOW PLUGS indicator light will stop flashing and stay on for 60 seconds after release of STARTER control switch. • If starter is not engaged within 60 seconds after GLOW PLUGS indicator light starts to flash, glow plugs and GLOW PLUGS indicator light will turn off. • Manual override of engine’s glow plug controller is accomplished by continually holding GLOW PLUGS switch to on, as directed by chief of section. 8 If engine fails to start, wait 10 seconds and engage STARTER control switch (14). If the engine fails to start, or if the GLOW PLUGS indicator light (20) fails to illuminate after four attempts, manual override using the GLOW PLUGS switch (19) may be used as determined by the chief of section. 2-282