TM-9-1290-365-24&P Technical and Parts Manual for Paladin Muzzle Velocity System M93 Upgraded Download
Page 74 of 334
ARMY TM 9-1290-365-24&P 3.4.3. Materials Required. Repair materials and other consumable item requirements are listed in Table 3-11. Table 3-11. Materials Required Nomenclature Part/Spec. No. Appendix f Item No. Adhesive S1184 3 Adhesive S1125 2 Label 43-143 10 Primer 747-55 17 Primer MIL-S-22473, Grade AA 20 Insulating Tube M22129CLR22AWG 25 Resistor 75 ohms, 1% 28 3.4.4. General Repair Requirements. Refer to Figure 3-10. Repair or replace connector as follows: NOTE The following procedure applies to connector P1. NOTE Before replacing a connector, ensure that the replacement connector matches exactly the connector to be replaced. a. Using connector pliers (soft jaw), remove shorting cap (1) from connector body (2) and slide away from connector (2). b. Tag and label wires. c. Using pin extraction tool, remove damaged pin and wire from connector body (2). d. Using crimping tool, crimp pin to 75 ohm fixed film resistor lead. Cover with insulating tube. e. Using insertion tool, insert pins into connector body (2). NOTE Failure to perform continuity check at this point may require complete disassembly of connector to correct improperly terminated connector pins. f. Perform continuity test of cable in accordance with para. 3.4.6. If cable checks good, proceed to step g. g. Using small wire brush, clean sealing compound residue from threads of connector body (2) and shorting cap (1 ). h. Apply primer to threads of connector body (2) and shorting cap (1). i. Apply sealing compound to threads of connector body (2) and shorting cap (1). j. Install shorting cap (1) on connector body (2) and torque to 3.7 ft Ib (5 N.m). 3-26