TM-9-1290-365-24&P Technical and Parts Manual for Paladin Muzzle Velocity System M93 Upgraded Download
Page 62 of 334
ARMY TM 9-1290-365-24&P 3.3.3 Materials Required. Repair materials and other consumable item requirements are listed in Table 3-8. Table 3-8. Materials Required Nomenclature Part/Spec. No. Appendix F Item No. Adhesive S1184 3 Adhesive S1125 2 Label 43-143 10 Primer 747-55 17 Primer MIL-S-22473, Grade AA 20 3.3.4 General Repair Requirements. Refer to Figure 3-4. Repair or replace cable connectors as follows: CAUTION Using excess force when cutting boot may cause damage to wiring inside boot. NOTE Before replacing a connector, ensure that the replacement connector matches exactly the connector to be replaced. a. Using sharp knife, carefully cut boot (3). b. Pry boot (3), off of backshell (2) and cable (4). c. Using connector pliers (soft jaw), remove backshell (2) from connector body (1 ) and slide away from connector (1). d. Tag and label wires. e. Using pin extractor tool, remove damaged pin and wire from connector body. Remove serviceable pins and wires also to facilitate installation of new boot (3). f. Remove connector (1) from cable (4). g. Move backshell (2) away from end of cable (4). h. Cut wire as close as possible to end of damaged pin. i. Strip insulation from wire as required to ensure that wire will seat properly in pin. Using crimping tool, crimp pin to wire. NOTE Failure to place heat shrink and backshell on cable at this point and in correct sequence will require later removal of connector from cable to facilitate install on of boot and backshell. k. Slide new boot (3) on cable (4). l. Using insertion tool, insert pins into connector body (1). 3-14